Question about Bissell Vacuums
...water tank off the unit and with the unit running and holding the spray button down pour water into the opening where the tank's fill cap was sitting. If it now sprays water then the valve in the cap ...
...water tank. Lift this off. There's a clip in the back to separate the top sweep section from the tank. Take off the top. You'll see an open hole on the top for filling the bladder inside. This is for ...
Question about Bissell Vacuums
water tank: Ensure that the clean water tank is not empty and is filled with warm tap water and the appropriate Bissell solution. The cap of the clean water tank should be properly closed. Re-seat the
...water tank if the Shark steam mop will not produce steam. Add water to the tank if it is empty. The mop will not make steam without water in the tank. To fill the tank, turn the tank cap ...
There should be a fill line indented on the tank. Usually this machine should hold about a gallon of water and you will want to use distilled water so that hard water doesn't plug it up down the road
Question about Bissell Vacuums
...sit a bit then plug it in and press the trigger several times until you get a good flow. Once all the vinegar is through the machine... put about a half tank of water through it as a rinse. Good
...you look at the bottom of your tank, where the water comes out, you may be able to see that the plastic is mis-shaped or deformed slightly. It probably doesn't take much for the seal to be broken. ...
...water tank. Remove it from the ProHeat by lifting the handle straight up. Carry it to the sink and then remove the top. Flip the latch on the back of the tank up. Note how the groove on the bottom ...
...water tank that your suppost to fill the water runs out before I even turn the machine on. I have tried using plugs to keep it from doing this just so I can shampoo my carpet, this seems to work to a ...
215 questions posted
Usually answered in minutes!
1,137 Questions
96 Questions
87 Questions
50 Questions