...unit is not warming up to the proper temp. Open the front to the right below where the cleaning clothes are kept there is a cover at about 45 degrees have to get on the ground and look at it there is ...
Question about Konica Minolta bizhub Office Equipment & Supplies
...covers (one screw on each) where the output elevator tray attaches to the finisher. Reseat all connectors on the finisher control board. The board may need replacing. Hi, the problem solved, firmware ...
Question about Sharp Office Equipment & Supplies
...finisher covers'' Copier was moved from it's location and then back again. When plugged back in I get the message ''close finisher unit and finisher covers. I can't seem to get it back to working ...
Question about Sharp Office Equipment & Supplies
message on sharp ar501 copier. close finisher unit and finisher covers. Check the finisher covers sensor or microswitch.or anymore mechanical components deformation.
Question about Sharp Office Equipment & Supplies
...finisher covers.....taken it out and put it back in again and its still saying the same thing? If you have open and closed ALL covers then you probably have a bad door switch. Try turning the copier ...
our copier ran out of staples, where do i put more in STAPLES WILL GO IN THE FINISHER UNIT.OPEN THE COVER AND REMOVE THE STAPLE UNIT AND PUT NEW STAPLE PINS
unit. Open front cover, push down on copier then lift green handle. remove screw just above toner suppy unit and remove your drum assembly. Next remove your developer unit(two latches hold it in place
remove the finisher/bridge unit What kind? most one screw in front cover pull handle tward you remove finisher
Question about Xerox Office Equipment & Supplies
...unit out of the Finisher until it stops. NOTE: The Staple Cartridge unit does not detach from the Finisher. Grasp the orange tabs on both sides of the Staple Cartridge and lift the cartridge out of ...
...Finisher is not closed." & "Close punch unit cover." I'm hoping it is an easy fix & I wasn't given a dud! Got any ideas how to fix it? There can only be two things wrong, one is the interlock and the ...
1,254 questions posted
Usually answered in minutes!
924 Questions
417 Questions
261 Questions
256 Questions
111 Questions