Ruud UBHC Air Conditioner "high amp draw heat pump" Questions

Amp where as rated current is 10.7, still the heating is OK. If this is aheat pump or reverse cycle unit that amps in heating is to high. Should not go over nameplate amps in heat or cool. Sounds like

...higher rating. Now if your high rating is during run time then you should replace the compressor capacitor and see if your amp draw falls in line. If it doesn't you most likely have a bad

...high amps and keeps going up until it blows the 40 amp fuse on heat only. and on cooling only works for a minute or two and shuts off and starts again but draws only 18 amps well below the 25 RLA on ...

...amp draw but does not pump any refrigerant. the indoor unit it is a split face coil with two buy direction txv. Very long pipe run, the suction line was a little under size but I check the pressure ...

draw high amps and overheat, some of your older motors have oilers on them that you can oil. As for manually defrosting your unit, usually you can, by being very careful and opening the wire box cover

High side low side pressures don not respond to freon levels I have a new 2stage Ruud heat pump. It runs well in cooling mode but makes a rumbling noise in heat mode. The rummbling noise is in sync ...

high voltage and low voltage but while its in cooling mode the back up heat is running. Why is the back up heat coil coming on while the heat pump is in cooling mode? If back-up heat comes on when a/c

...high an amp draw for a certain period, the compressor overload will shut it off but the fan will continue to run. Too low would be low freon most of the time. 2. There could be an issue with the ...

...amp breaker.Need Help Would suggest it is drawing excessive current, make sure both fans are going, (inside will cycle low/high), or possible faulty reversing valve solenoid, or could be as simple as ...