Ruud UBHC Air Conditioner "gas pressure split unit 2" Questions

Ad

Question about Heating & Cooling

3 Answers

...gas pressure & quantity in 1,1.5,2 ton split ac? carrier 2 ton ac gas pressure detail The quantity by mass varies from unit to unit. The factory charge is usually stamped/printed on the nameplate ...

Ad

Question about LG Heating & Cooling

1 Answer

...gas in split a/c 2 tonand1.5 ton a/c what is the pressure i should maintain for this. Pls tellme sir. The pressures are based on ambient temperature outdoors and temps indoors. Also, it is based on ...

Ad

Question about Heating & Cooling

1 Answer

...low on charge. on your valve there are little tubes that help the 24v coil by pushing pressure against valve. if not enough presser the valve wont shift. put 2 pounds of gas in and see what it ...

Question about Sanyo Heating & Cooling

2 Answers

pressure when I undid the fittings to remove it from the wall. Yet it leaks oil when running and cooling. What is up with that? RE TIGHTEN THE FITTINGS WITH LEAK USING TO WRENCHES AND MONITOR THE LEAK

...pressure about 40-45 psi(air cond is running) then use a allen key(hexagonal wrench) to close 2 way valve(small tube or gas discharge side) wait 1-2 minute then close 3 way valve (suction tube or big ...

Question about LG Heating & Cooling

2 Answers

split air conditioner purchased two year back.Since then it was o.k. but now in this summer season ,when it was found that whole gas happened to leak , it was serviced and the service man just charged

...gas and said that everything will be ok and went away. But again after a few days I started facing the same problem. Now I am at my witsend about what to do and how to explain the problem to the ...

Question about Ruud Heating & Cooling

1 Answer

pressure drop. scroll compressors. check the true psi with the line psi to see if same if psi is good in cooling 225 hi and 70 low on 80'day then compressor is fine and i would start checking for temp

Question about Ruud Heating & Cooling

1 Answer

...as short cycling and is normally caused by your thermostat.Or the unit is starting up under large gas pressure loads due to air in the system and or moisture and can only be fixed by a new gas ...

...gas valve when you call for heating. Things that may cause you not to have 24 volts: 1. Does the draft inducer motor start when you call for heating? 2. Does the pressure switch close after the draft ...

Not finding what you are looking for?
Ruud UBHC Air Conditioner Logo

779 questions posted

Ask a Question

Usually answered in minutes!

Top Ruud Heating & Cooling Experts

Brad Brown

Level 3 Expert

19187 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Ruud Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...