...furnace fan runs when funace is off. Previously replaced thermostat. Furnace fan began running when furnace was off, eventually burning up fan motor. Replaced fan motor, but fan still runs when ...
Question about Heating & Cooling
...furnace, the fan relay will be incorporated into the control board and cannot be replaced. Both of those answers above pertain if the furnace is a natural gas or LP furnace. If it is an electric ...
Question about Heating & Cooling
furnace starts and ignites and fan comes on but when thermostat is turned off the gas shuts off and flame off but furnace continues to run. whu?? any suggestions? The fan normally runs for a few ...
Question about Carrier Heating & Cooling
...mode and see if fan comes on(switch fan to on at thermostat) if it does not a fan problem or capacitor problem. when in cooling mode thermostat controls fan, when in heating mode, furnace controls ...
Question about Heating & Cooling
...furnace it has a separate fan relay). If it does not operate normally in the heating mode, verify power to the furnace, see if the flame comes on, if it does: the fan motor, circuit board or the fan ...
...Furnace needs power for controls, fan and thermostat. Are you sure you have electric power to the furnace? Does the thermostat have a fan switch? If so turn it on and see if the fan turns on. If it ...
...the neutral of the trans former . BE SAFE turn off power. r = Red wire Hot w= White wire heating g = Green Fan y= yellow cooling if their is a B or C @ the furnace terminal board that the neutral . ...
...fan on furnace will not turn off in aux.mode even though the furnace heat kicks on and off. thank you for any info.Ray Make sure fan relay is wired correctly (G) wire. Ensure the fan on therm is not ...
fan depending on the furnace. First make sure that your thermostat is not set to "fan", then the next thing to check is the limit control (gas or oil furnaces) These are just replaced as they wear out
Question about Bryant Heating & Cooling
...furnace fan will not turn on. Everything is sequencing, the induction fan starts and the flame lights, but the fan will not turn on. The capacitor reads 4.86 uf. Any suggestions? Your fan delay relay ...
24 questions posted
Usually answered in minutes!
91 Questions
97 Questions
82 Questions
79 Questions
37 Questions