Weather King 12AJA4801AH Air Conditioner "furnace cut times others" Questions

...when it is really cold outside. At other times the furnace works fine. Any suggestions. sounds like you have a heat pump heat pumps dont work below 30* temps you should have some type of backup ...

...times the furnace works fine. Any suggestions. Check the data information on the unit there should be a troubleshooting guide that tells you what the two lights blinking once means. hope this ...

...furnace is where you can hear it easily. I have not found and quick cure for it so unfortunately you will have to just deal with it. if this noise is comming from your control transformer or possibly ...

WHY DOES MY FURNACE SHUT OFF BEFORE REACHING TEMP Hi Demetrio Furnaces turn on and off based on what they're told by your thermostat. The thermostat, in turn, will control the furnace based on: The ...

Ruud furnace won't stay lit. Our Ruud furnace has an electric ignition. When it get so hot the flames come on. But the flames only burn for about a minute then it cuts off. It is not reaching the ...

...furnace is 24 volts. Really without a load on the transformer usually runs 28 volts then you put a load on it and it drops down to 24-26 volts. Check the voltage between the R terminal and the W ...

...cut on 8 year old Goodman CPLE24-1 AC for the summer. Ran 8 hours fine, Next morning noticed outside unit running, very little cool air blowing out of inside floor vents (like the blower fan was ...

...cut a wire to the unit. I replaced the wire but now the unit wont turn on and also my furnace blower wont work even in the "on" position. I have a energy saver unit attched to the a/c unit as well. ...

i have a dayton fuel trimmer furnace model # 3E438A and the problem is that upon ignition to the furnace the unit runs and after about 3 minutes the units inducer fan shuts off and the flames stays on

...cut-off. Furnace will then re-start and the run through it's pre-cycle, just as if the thermostat just called for heat. Furnace then fires up and runs perfectly for a few minutes then the gas supply ...