Frigidaire ATF6000ES Front Load Washer "remove softner cup" Questions

softner into the washer Try removing the dispenser cup - and washing the inner cup thoroughly- run a sanitary cycle with whites and chlorine bleach mold and mildew likes to haunt these front loaders -

...washer. (if you get it out, then thoroughly clean everything up, then file down the front of the softner cup so it will not happen again--or throw away the softner cup and stop using softner) GOOD ...

...softner. if the cup is removable, remove and soak in hot water Take the top off, three screws in the back, top front left is the dispencer assembly, you will see some crusties(thats what I call them) ...

...remove the soap,softner and bleach dispenser look in side and clean were dispenser goes and when this is goig on spray drum with bleach as well, use gloves and have plenty of ventilation,after ...

...remove the clear cap underneath, it is very difficult to get the seal on it to seat back in properly. To help prevent against future build ups, pre-diluting your fabric softner with water ahead of ...

...liquid,pour it into that cup,if using powder detergent remove that cup and the powder goes there. The Bleach would go behind the detergent& and softner would go in the right rear compartment ...

...softner is still in compartment. I had a similar problem and removed the complete dispenser drawer and washed it in with hot water. The small inner cups for the fabric softener and bleach should be ...

...softner in the dispenser cup and when the load is finished, it is still there. It does not dispense. this is a simple blockage. you can fix this by removing the dispenser cup and transfer tube. just ...

...softner section, i have tried to clean inside the compartment with a tooth brush too and tooth pick but no water will rinse in that section, clogged from the top part of the machine?? remove soap ...

remove the agitator to clean the liquid softner dispenser, it is clogged Liquid softner is still in the cup after the spin cycle. Looks all clogged and moldy. How can I remove the agitator to clean it