Whirlpool MH1150XMQ Microwave Oven "sparking back 2" Questions

...sparking. Can see flashing through plastic. 1.Needs to remove that disk and clean the grease under it. 2. With sand paper clean dark burn spots. 3. Apply touch paint on open metal spots. 4.Put ...

...back there are 3 semiconductors 1 bridge and 2 high current transistors the right smaller one shorted taking also 2 pcb resistors fried next to it solution replace these components try again drain or ...

...will not heat up and a spark comes out the back when you turn it on after it makes a loud pop noise. Only 2 years old It is the magnetron that has shorted, heats food, cheaper to replace than

...back in there are short. go to www.repairclinic.com for to get the parts.2) test the switch door for short and replace  see the diagram3) test the high voltage capacitor+ high voltage diodesee ...

...back out. He said it looked like it might be arcing so he put cavity filler stuff up on the ceiling under the blade area. It still sparked. Tech #2 came out and said that the blade must be defective ...

...back center, two times and haven't used it for the 2 weeks passed. Any Ideas? thanks ahead That would be ACM1580AB, just in case that was throwing off your searches. If the noise came from within the ...

2 seconds, relay clicks, unit goes off. Cook time on display goes off and clock time comes back. Bad upper interlock switch and charred connector If so, see http://www.microwavedisplay.com/safety.txt

...back center, two times and haven't used it for the 2 weeks passed. Any Ideas? thanks ahead [email protected] That would be ACM1580AB, just in case that was throwing off your searches. If the noise ...

...back in an still no power. I would greatly appreciate if you or someone who has resolved this problem can help me. My Whirlpool MH3184xps is shooting a spark when in use with the rack. When the rack ...

...back again and replaced the same Noise Filter board. It worked for about 2 weeks and the same problem started again. The microwave does heat and if after you keep resetting the clock it will ...