Whirlpool GHW9150 Duet Washer "water destroyer" Questions

Ad

Question about Whirlpool duet Washing Machines

1 Answer

WATER LEAKS BAD Water leaks bad when I use the washer, it comes out from all the seams, I got the drawers to set the washer on and it leaks inside them. I stored my books inside the drawer and they ...

Ad

Question about Whirlpool duet Washing Machines

2 Answers

renting an apartment and they didn't leave the manual Failure Code - FH Fault Code Description - No water detected entering machine or Pressure switch trip not detected. Solution - If after 30 seconds

Ad

...More than likely the washer tub bearing is worn out, this happens due to seal failure and soapy water getting into the bearing, the soap is very corrosive and the bearing fails quickly, this in ...

...the seal between the inner drum and the heavy bearings, also not available separately, and lets water into the bearings in the aft outer tub which support the inner tub shaft. If you want to try ...

Question about Whirlpool duet Washing Machines

6 Answers

...any help so I know what happened. Thanks Gus According to the tech sheet I have, F24 is a water temp sensor error. If the sensor reading is not within specs during the water heating portion ...

Question about Whirlpool duet Washing Machines

9 Answers

...blanket on the floor to protect the washer's finish. Make sure the machine and hoses are drained of water. Tip the washer over on its front or side to gain access through the bottom of the machine. ...

Question about Whirlpool duet Washing Machines

1 Answer

... of Oxy Clean, with my detergent but I decided to go full-strength which on the box said 1 cup. Hot water wash. Put it in with the clothes. Same liquid detergent, no fabric softener. When I took out ...

Question about Roper Washing Machines

1 Answer

...then it just shut down completely and now will not turn on, any idea what the problem is? Replaced water pump, found 2 quarters located within the old water pump which destroyed the o-ring causing a ...

Question about EuroTech Washing Machines

1 Answer

Water Temperature is hot on all rinse cycles Water temperature on rinse on all modes is HOT. Water is hooked up correctly (the delivery folks hooked it up when installing). Steaming hot - too hot to ...

...and seal surfaces,the sooner you get to it the less chance of severe damage it will cause,because water will kep on destroying bearings till they lock up and destroy the drive ...

Not finding what you are looking for?
Washing Machines Logo

89 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...