Whirlpool GHW9300 Duet Washer "door lock light" Questions

still won't open. When I plug it back in the door locked light is back on. Hi, Press and hold the End of Cycle Signal button for three seconds. This will turn off the Control Lock feature. Thank you !

...SW France, The door lock light indicates there is a problem with the door lock. Either the locking solenoid or the door lock sensor is malfunctioning and requires attention. Sorry- Service call! John ...

...door lock light blinking. start button light on. won't do anything. IT IS POSSIBLE YOU HAVE A DEFECTIVE DOOR LOCK OR CONTROL BOARD. CHECK YOU OWNERS MANUAL TOO SEE IF YOUR WASHER HAS A MANUAL RELEASE ...

...lock. Does water remain in the washer after the final spin? If water remains in the washer after the final spin, then the door will not unlock. Drain/Spin or Spin Only to remove any remaining water ...

...door lock. Check to be sure that the control lock light is off--if not, hold end of cycle button again till control lock light goes off. I've given up on the door lock after a few years fighting it, ...

...lock light is on my Whirlpool Duet GHW9150PW0 model and will not go off or allow the clothes to be washed. I have tried the pause/cancel unlock door button, unplugged the machine, and the control on ...

...door lock light doesn't come on and washer won't start. Code shows f dl? The door lock and switch assembly has failed. You may actually hear it click several times before the code appears. If not, it ...

...Lock light stays on The front door was opened when the machine was operating and the control lock light stayed lit. I've tried opening and shutting the door, disconnected the power, held the pause ...

...door lock light won't turn on to be abele to start the washer machine when you close the door,door lock light won't come on f22 error code apear and washer machine won't start ...

...door lock unit out few times, disassembled, looks good, still problem, tired to unplug it to erase error, such a headache.... The main controller board seem to be a problem, relay is not functioning ...