...a pinched hose or the fitting is overtightened or not tightened enough. turn off the water supply and check the water inlet hose. you can usually tell if the fittings are stripped or not tight
...water supply Hot and Cold faucets. Here is a quick test procedure that you can do to verify the operation of the Water Inlet Solenoid Valve. Verify that your water hoses are hooked up and the water ...
Question about Washing Machines
...is a wee bit stiffer. Any clues? Is definitely the tub not the machine as I have checked the flow without being hooked up to the machine. Turn off the water supply and strip the tap, fit a new
...water supply (hose and faucet) check out fine Two things will cause that problem. 1) Switch water off and remove pipe off of the machine side. You will see the inlet to the water valve. Normally the ...
...water supply line to the washer. The drip is slow and seems to be coming from near the top/under the lid. Water valve letting by, could be diaphragm split or filter partially blocked causing too ...
...water supply when used, thus leading to the occasional flooded kitchen. Any ideas on what It should look for, please? Sounds like a sticking water solenoid valve. Either the internal diaphragm is ...
Question about Hotpoint Washing Machines
supply and water supply remove the two screws that secure the interlock this is what the doors catch sits in reach down and tilt slide it out remove the plug plug in the new one and remount screw back
Question about Bosch Washing Machines
...water supply. On the lower right of the front panel is a 6" / 15mm cover. Near the bottom of this cover is a small hole. Insert a piece of wire into this hole, and push in gently. While pushing, turn ...
Question about Whirlpool Washing Machines
supply hot water via the hot fill pipe. Check the wash water with a thermometer. 40c is right for most poly/cotton fabrics. Use a liquid detergent. This should not be a problem. Check dosing levels on
...machine requires water, then when power is removed they seat back down again and use the incoming water pressure to hold that seal There is probably a bit of dirt under the seal and this will allow ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions