Whirlpool Duet GHW9150P Front Load Washer "hot tub pump clicks turns" Questions

...hot and shuts down or because of a problem in the control mechanism which manages the the starting and run time of the pump. First, I would unplug the washer from the wall outlet and probe under the ...

...hot. Fixed that and made sure there was a jet stream of water coming out of each hose. Still stuck at 28 minutes flashing. Turned washer off severl time for 20 minutes or more each time. Still stuck. ...

...hot water shuts off in the middle of the load with an error message reading fh. Please help me out and let me know what part needs tobe replaced or fixed. Thank you FH error indicates that either you ...

...tub. If the pump is getting warm current is flowing to it and propeller is jammed more than likely. The front should have a couple of 1/4 screws at the corners on the front I think. should pop after ...

...hot water inlet valve opens and fills the tub up to the wash level. Quick Wash ----- The drum executes a reversing movement at wash speed for 30 seconds. Normal/Casual ----- The drum executes a ...

...hot goes in fine,then the pump released the water fine. I changed the belt. Could this sound to you like the electrical motor has gone? Many thanks for your patience. Many Regards. W. Lima Open ...

...tub. Went throught the diagnostics and machine worked fine. Put a small load in and failed at the end of the cycle...did not properly drain nor would it spin, however, it did agitate. The pump seems ...

...tub - or no hot water - or no cold water Check that the water supply valves are turned on Inspect the water supply hoses for kinks Check the filter screens Test the water level switch Test the water ...

...hot. if it stops and starts it coule be a power board problem If your washer won't drain, check these: It spins, but doesn't pump It doesn't spin or pump It pumps, but the water returns It spins, but ...

...hot water should enter through the detergent compartment. 3. Turn the program knob (2) clicks from the start position. The bleach water solenoid will activate and cold water should enter through the ...