Whirlpool Duet GHW9150P Front Load Washer "dryer getting wet" Questions

...wet. Then put them in dryer, on low or fluff cycle. Run for 60 minutes or more. This should rub off all the ink in the dryer. You may have to repeat if you have alot of ink. I have done this a few ...

dryer.energy efficient too!! I always let the washer run about 2 mins which is usually long enough to wet the clothes really good then I hit the cancel button twice and it will empty any excess water,

...wet? You can perform some Whirlpool electric dryer timer troubleshooting to determine if the timer is faulty or if the cause is somewhere else within the dryer. Access the Timer Unplug the Whirlpool ...

...wet vac as sensibly suggested by VinnyB1234!) If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!). These ...

...WET AFTER THE CYCLE FINISHED, I TURNED ON THE CYLCE THAT SAYS DRAIN AND SPIN , AND PUT IT ON HIGH SPIN. IT NEVER WOULD SPIN ON HIGH. WHEN THE CYLCE FIRST STARTED IT LET MORE WATER INTO THE DRUM AND ...

...wet, I knew the drain was stopped up again. This is probably also the cause for the suds -- it's just not draining properly. Hope this helps -- I had SO many problems with my front load (with the ...

...dryer (I do dry them thoroughly), but smell really bad as soon as they get wet--it is disgusting. I have tried everything, and yes, I leave the washer door open all the time when not in use, and yes, ...

...wet I have the Bendix washer dryer.My clothes wash but then makes noise of spinning but never moves.When it gets to the drying part they are soaked and again it will not spin for the dry part.Whats ...

...dryer when drying heavy duty clothes The clothes then are too wet for the heat to evaporate. Spin extra time to get rid of as much water as possible before putting them in dryer. Thanks for using ...

...dryer, still dripping wet There is a water pump in the machine which pumps the water out of the outer tub and into the drain, after the wash and rinse cycles. It is possible that this pump isn't ...