Fabric Softner The fabric softner dispenser always remains full of water that is normal you can either add water to make it drain or pull out the drawer and dump it.
Question about Whirlpool duet Washing Machines
...softner does not drain After Each load the tray that holds the fabric softner does not drain and fills with water. We have removed the tray and cleaned it but did not help. I have had three sepaerate ...
Question about Whirlpool duet Washing Machines
...softner to the detergent compartment but I broke down and called a repairman to come tomorrow... at a ridiculous repair rate. My washer is less than 3 years old and this will be the 3rd major problem ...
Question about Whirlpool duet Washing Machines
...softner will not dispense I cleaned out the drain lines and filter at the pump and that did not fix the problem. The pump did not "sound" right so I then replaced it. It will pump water with the new ...
...Softner will not drain? That stuff tends to build up in there.. Might be clogged.. See if you can get the dispencer drawr out and clean the pathway of the softener.. Hope this helps !! Please rate me ...
...drain normally then pressure sw is likely the problem. 1. did pump come on? if no replace pump 2. is unit draining at normal rate? no then clean pump. if yes on both replace pressure sw. to second ...
Question about Whirlpool duet Washing Machines
...drain or use the fabric softner. Any help would be great! Thanks! "F21" (AKA SD) is a Long (SLOW) Drain error (LD). If the drain time exceeds 8 minutes this error code will be displayed. In addition, ...
Question about Whirlpool duet Washing Machines
...drain after cycle finished. Water stays in it. After a load of laundry has been washed, the reservoir on my Whirlpool Duet Washer where the detergent, softener and bleach go always has water in it. ...
Question about Whirlpool duet Washing Machines
...softner . mixed with a quart of water . wait over night . and everything will be ok . f35 ?? it will probably go away also . if it does not get back with me. . no to stop this from happing again cut ...
...drain pump, flow meter and main control are seated properly. You will have to remove the top to get a look at these. Three screws on the top backside and it slides of toward the back. If all these ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions