...F06 and F14 error codes. The door lock repair is quite easy. Unplug from the wall, remove the band spring on the door seal (20 in diameter or so), then remove the 3 Torx screws from the door lock ...
...F06 = Drive motor tachometer error The controller cannot properly detect the motor speed and the machine will shut down. If the faulure occurred during a high speed spin, the door will lock for 3 ...
...door is locked. You can try to reset the cycle and nothing happens. Hi Thanks for using FixYa. Error F06 in your washer indicates that the control is unable to properly detect the motor speed and so ...
...door locked. How can I restart machine or unlock the door Unfortunately, this error means that the central control unit and user interface aren't communicating. Sometimes, a temporary solution can be ...
...door to unlock. I ran a diagnostic test, and the washer went through the sequences, the water worked (both hot and cold) but the drum never turned. Afterwards, I received an F06 error code, and then ...
Question about Whirlpool duet Washing Machines
...F06, F11, F23, F24, F27, F28, F29, F30, F31, F32, F35, F42, F61, F62, F63, F64, F65, F70, F71, and F99 If Pause/Cancel does not work: Unplug washer or disconnect power for one minute. Plug in washer ...
...door in the locked position. Pin 3 is ground. At the opposite end, this is the 4th connector from the right on the front of the CCU. NOTE: All the connector pins are numbered R to L. If your ...
Question about Whirlpool duet Washing Machines
...DOOR IS LOCKED DOOR LOCK SYSTEM C:01 FILLING BY COLD WATER INLET FLOW METER. COLD INLET VALVE C:02 DISTRIBUTION SYS IS SET DISPENSER MOTOR TO PREWASH POSITION DISPENCER CONTACT C:03 FILL BY HOT WATER ...
...door is locked. How can I reset the washer? F6 code is an issue with the motor drive tachometer. Most often this is caused by poor connections at the machine control or motor controller. Locate the ...
Question about Whirlpool duet Washing Machines
...door in the locked position. Pin 3 is ground. At the opposite end, this is the 4th connector from the right on the front of the CCU. NOTE: All the connector pins are numbered R to L. If your ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions