GHW9150 will not start, door will not lock. No codes on display Has power and water. Hello, This means that the CCU on the rear of the washer has an electronic glitch. Try unplugging the washer for ...
...won't drain nor spin. Hi there I hope this helps you. F/dL Door Lock Error A Door Lock Error occurs if the door cannot be unlocked. It will try to lock it 6 times before displaying the error. ...
ghw9150 washer? Try unplugging the washer for 5minutes or turning off the breaker will do too! then after you turn on the power the system should be reset and problem may be solved! If for some reason
...GHW9150 Front Load Washer show code F then 11 flashing and the washer does not continue unless you touch cancel, wait a few minutes, and touch the start again. Sometimes, it works and continue the ...
...connections to; Inlet Valves, Pressure Switch, Drain Pump, Flow Meter, and Central Control Unit (CCU) ? Check all hoses for possible leaks ? Verify pressure switch operation ? Verify flow meter ...
Question about Whirlpool duet Washing Machines
...returns the f/h error. Replaced pressure switch, tested flowmeter by blowing into it, and replaced CCU. Drain pump spins but does not drain. Drain pump sounds noisey. Checked filter and nothing in
...wer hat einen rat? "F11" is a Serial Communications error between the Central Control Unit (CCU) and Motor Control Unit (MCU). The CCU is the main computer for the washer and is located ...
...you need to order parts. For the GHW9200LWO Washer (Sanitary Cycle Model)- the part number for the CCU (Microcomputer or main computer) is 8181924. The part number for the Motor Control Unit (MCU)
...is a trouble shooting book,f 06 is a drive motor problem. YOU NEED TO REPLACE THE MCU AND THE ...
...the pressure hose and the pressure sw.if all of these does work ok then prepre to replace ccu ;mcu and interfase boards this is a terrible code good ...
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions