...11 F. I have tried unplugging the machine but it comes on right where it left off. Now the door is stuck locked and I can't even get the wet clothes out of it. Is there any way to reset it? I don't ...
Question about Whirlpool duet Washing Machines
...Sears and neither source was helpful, they suggested using a local technician. THIS FIX TOOK 10 Minutes. DO IT! 1) take (3) screws off front lower panel, remove panel. 2) unscrew ground wire off on ...
...11 error code in spin cycle The first thing u must do is ID who makes this machine for sears, sears doesn't manufacture anything, here is the page that shows you how to do that, then with that info i ...
Question about Whirlpool duet Washing Machines
...Sears repairman said it needed a $500 control board. Is this true? Could it be something else? yes!! the F/11 is triggered under high voltage conditions like high speed spinning. The part is called ...
...Sears but they can't come out right away to help with the issue. Please help me!!! Here is what Kenmore says. F/11 Serial Communication Error Communication between the Central Control Unit (CCU) ...
...11" error code. Tried the suggestion of: cancel, push drain and spin, put spin speed to 'no spin,' push 'prewash' four times to put machine into self test mode. Machine will start the test, but a few ...
11 through 14 back to front). - Check the Drive Motor. Remove the connector and perform resistance checks on the motor connector pins. Readings across pins 1 to 2, 2 to 3 and 1 to 3 should read 6 ohms
Question about Whirlpool duet Washing Machines
11. ??Washer has stopped at 26 min with water in the drum. Will not spin or drain. Just sounds like it starts running then stops and repeats.?? I believe this is the start of a Spin Cycle of that Wash
...11 to 14. If you are carefull to blow softly you can test each for continuity, if no beep replace. Also your water inlet valves should read between 860 and 950 ohms roughly, any reading in the k ohms ...
11:58:03 pm, and you can search for my name - "monettsys" The same problem will occur with any machine that uses tin-lead contacts in the conectors. Best Wishes, Mike Monett www.pstca.com for code f11
11,378 questions posted
Usually answered in minutes!
187 Questions
64 Questions
34 Questions