...120 volts) to H2 and H4. Then for the 24 volts secondary X1 is one side of your 24 volts and X2 is the other side of your 24 volts. For 240 volt primary connect H2 and H3 together, Then connect one ...
= 120 volts 887B = model number of the switch 34-191 = date code 15 amp = ampacity rating of the switch 120 vac = Again this is a 120 volt switch A/C If you need anymore assistence please comment back
Question about Fahrenheat Heating & Cooling
..... the current would increase to a little more than 6 amps per heater .. some heaters have a jumper you can move for 120 volt service or 240 volt service... you can use those with either voltage
...bad transformer. if you are getting 24 volts but the inducer motor is not running than check for a 120 volts at the inducer motor if you are getting 120 volts to the inducer and it does not start ...
igniter wont ignite furnace Hello, if you are getting a 120 volts to the ignitor and yet does not glow it must replaced, however if you are not gettig 120 volts it could be a problem with the pressure
Question about Heating & Cooling
...to ignite the pressure switch must close, once the switch closes the control board will send 120 volts to the igniter. If you have a 120 volts to the igniter, but does not ignite, this ...
I mistakenly put 240 volts into heater instead of 120. It ran twice for about 3 seconds. Now I changed it to 120 volts, element goes on but fan does not. Did I burn out a fan fuse? No you burned up ...
Question about Fahrenheat Heating & Cooling
...makes no sense to me, is this correct? If is 120 volt heater.The thermo can use 220 or 110 volt.The elec is only using the 110v half/side of therm.Should be ok.Does it work?OK to leave blacks
gms80904bna i have a furnace that has 120 volts to board and transformer. 24 volts to the r terminal on board but i have no 120 volts to the inducer motor. i have tested at the motor and the board but
...120 volt line) . The white wire should be the neutral. The green should be the ground. Check these connections and test them to make sure they are correct. You should get 120 volt reading between the ...
132 questions posted
Usually answered in minutes!
31 Questions
29 Questions
18 Questions