...heat and keeps the gas valve open for gas to flow through,when calling for heat and also keeps the pilot light lit. Try replacing it,br sure all gas is off prior to doing any work to unit. Hope this ...
Question about Coleman Heating & Cooling
heat. You can try to clean it with steel wool and make sure it is tight where it goes to the gas valve. Make sure it is on the top center pert of the flame as this is the hottest part of the flame. If
...gas valve is there a pilot position? If so turn it to pilot position and push down on the knob, with the system calling for heat,,,so that you are hearing the buzz, if it does not light, push down on ...
...works but will not fire The motor you are hearing may just be the inducer motor, this is the one that creates suction in the system before the gas is released/ignighted. If the system turns on, and ...
gas valve and see if the unit works when you release the button. Here is a link with some more instructions. http://www.msservice.net/ts/reseat_thermo-clean_pilot-ODS.htm If this does not work you may
...pushing in the pressure switch with a screw driver while its calling for heat, the inducer kicked on and it cycled fine, and its running now. What is stopping the sequence. Intermittently? Any ideas? ...
heat. The pilot light is on but does not accelerate. When I switch the furnace from auto to manual the fan comes on but again, the pilot light does not ignite so only cold air is pushed. The household
heat up and hold the gas supply open. If this is bad the unit will not start and will not continue to run. I would check into changing the gas hold on valve. See my tip at http://www.fixya.com/support
...pushing in but as soon as I release the valve it shuts off. I took it apart and the valve routes gas where its supposed to with the tip switch coil removed. With it installed there is no gas to the ...
52 questions posted
Usually answered in minutes!
63 Questions
29 Questions
25 Questions
19 Questions
19 Questions