hard is in front of you, you'll see the connection of the ide cable and power cable, then the jumper setting pins is in your left,am i right?..so the pins is figure like this, : : : ., is that right?.
.....need to know settings for single/master drive Put the jumper on J50(the closest set of pins to the IDE connector) This will set the drive to master, with no pins on it's currently set to slave. ...
Question about Maxtor DiamondMax Computers & Internet
hard drive was freezing up .i have already replaced and reloaded now i would like to slave this h.d. to recover my files. i need to reset the jumpers. it is a maxtor n256 model 33073u4 On the back of ...
Question about Maxtor DiamondMax Computers & Internet
hard drive . could it be pin settings? this Drive is a slave drive Take a look at this pdf:eshop.macsales.com/Tech/manuals/idehdsettings/Maxtor72.pdfSo If this is layout " : : : . : " then...slave ---
pin off of the hard drive. Just a note though, I highly recommend using a peice of scotch tape to affix the pin to a nearby surface cause there a real pain to find if and when you need em again. Chris
...you'll see : MS, CS, CAB, a space and TXD. Cheers it's usually written on the drive itself. Squint hard! Right by the jumper pins should be some letters. MS, SL, etc. remove all jumpers for slave
...second hard disk.. by the way make sure not to connect it to the same cable as the cd ,dvd or other wise known as the optical drive's cables... it will greatly decreasy that hard drives
Question about Maxtor DiamondMax Computers & Internet
Hard Drive? Can anyone supply a diagram? Look at the picture, I cannot memorize all hardisk jumper but almost all drives have label in it. where you put the jumper for the Cable Select, Master, Slave.
Question about Maxtor DiamondMax Computers & Internet
...hard drive but only 32 gb is visible Check your jumper settings on the drive it sounds like youve got the jumper over the 32gig limit pins.....cheers from Scott and plz vote You hard drive may have ...
Question about Maxtor DiamondMax Computers & Internet
...hard drive i installed on a winme operating system...bios recognizes it but it doesnt show up in my computer i installed it correctly switching it to the slave drive Can you boot the computer from a ...
29 questions posted
Usually answered in minutes!
19 Questions
17 Questions
9 Questions
8 Questions