light, then nothing. I have tried removing the power cord in the off position. Then, repulsing in and turning on. No solution. Help! the sequence that the lights flash is how the error codes are given
sequence in this step. When the alignment page has printed, place the page face down on the scanner glass and press Scan . The alignment is complete when the On light stops blinking. Reconnect the USB
...sequence in this step. 4. When the alignment page has printed, place the page face down on the scanner glass and press Scan . The alignment is complete when the On light stops blinking. 5. Reconnect ...
...light sequence and continue processing the print job. With the printer turned off, remove the toner cartridge and shake it to extend its life. Check the replacement toner cartridge if it is the one ...
...light sequence and will just default to a error light and a toner low light ( though toner was recently replaced and worked ) Any Ideas ? After replacing the drum unit you have to tell the printer ...
...light sequence. Normally if the red light is on and nothing happens the most common fault is the fuser unit is not warming up. You will have to replace the fuser unit, but this all depends on the ...
Question about Kyocera Mita Office Equipment & Supplies
sequence in this step. 4. Once the alignment page is printed, place the page face down on the scanner glass and press Scan. The alignment is complete when the On light stops blinking. 5. Reconnect the
sequence in this step. When the alignment page has printed, place the page face down on the scanner glass and press Scan . The alignment is complete when the On light stops blinking. Reconnect the USB
...light sequence that you see for the "Factory Defaults". 12. Press and release the Cancel button to advance through the menus and the menu items to the one we would need. 13. Press and hold the ...
...reset the imaging drum's counter. To reset the counter, press and hold the Cancel button until all lights flash in sequence. After you replace the imaging drum, you should reset the imaging drum's ...
62 questions posted
Usually answered in minutes!
180 Questions
128 Questions
77 Questions
66 Questions
63 Questions