...tank holds the water and detergent. I have a hoover steamvac clean surge. There are two tanks. do i put the water and degergent into the tank that only has a cap? Does the tank that has a filter is ...
...it heat the water? when I empty the holding tank the water appears not to be hot. I believe it does not heat water. you put hot water in w/cleaning solution. it is cool by time you empty holding
...water on both sides. Hold the tank up and observe if water leaks from the valves underneath the tank. If either of the valves are leaking the clean water tank will need to be replaced. To order a ...
Question about Hoover Vacuums
...water tank on its own is holding water but soon as I connect it to the machine the water starts to drain out the seal between the vac and the tank is bad,you can most likely get a replacement from ...
...hold in the cleaning solution is broken I am assuming you refer to the solution tank valve. there are 2 basic models, a one compartment that holds the soap and water mixture and the 2 compartment ...
how much fluid does the measuring cup hold The boiler tank will hold two cups of water and/or steam. For best results use only one cup of water in the tank.This will allow for expansion of the steam.
...hold it for about 30 seconds. You should see water gathering around the brushes. If not, that is a problem. With water around the brushes, release and lower the handle and and move the machine over ...
...shape center.. hot water. prime from hose without a tool on it by holding the hose lower than the tank.. put in on a work bench.. hold spray trigger and turn on machine.... read my other posts as ...
water) tank. The tank comes out but the stuff doesn't rinse out - its gross. I'd like to take the holding tank apart to remove the insides and clean them, but it appears glued. Recommendations
50 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions
