Aurora Electronics AS882C (Cross-Cut) Shredder "alignment" Questions

...bin full sensor is either: 1. clogged with fine dust from the shredded paper, or 2. knocked out of alignment, Cleaning is as easy as spraying the sensor with compressed air. Mechnical alignment can ...

...unit to run in "forward mode." Hello. Remove the cover, and check the micro switch for alignment. With use, they can get chad or other debris behind them that will not allow the switch

...turning it back on, but no luck If you can disconnect the power to unit and check shredding blade alignments to see if there is a clog or if the blades are out of alignment and stuck. If there

...in reverse and goes on in forward but sounds rather rough and won't take paper. Sounds like out of alignment. Actually this is more than likely a broken gear. Unfortunately we no longer have any ...

light is on for "door light is on for "door open", cant get shredder to work.... The switch for the door is not working properly. Not sure exactly how this model is set up, but the switch ...

a old card, carefully but forcibly push the jammed plastic strip through the teeth. might be faulty alignment of teeth, a factory defect

...of the blades. Hello, Sounds like the internal gears or drive shafts are either broken, or out of alignment. Not exactly something that can be easily fixed usually. Hopefully, it's still under ...

...will have to be replaced. Try Radio Shack or an electronic supply store. Also, check the door alignment

...aligned? Martin, The manufacturer puts spacers between all of the blades to keep them at the proper alignment. If you are having issues with paper balling up in one area, it may be that one of those ...

Dynex shredder was working fine with no issue. After 5 days when plug in to used the light on the right side where it shows the top and bottom not align lights up. NOt sure why when bottom and top fit