Asko W6021 Front Load Washer "drum 10 year old top" Questions

...drum on my washing machine is off center after spinning violently with an out-of-balance load. This machine is more than 10 years old. Is it cheaper to repair it or replace it? would recommend repair ...

drum has become loose and floppy ,can it be re attached easily or better to get a new machine it's 10 years old It is a good machine and still has life. The most likely cause is loose or broken damper

...should help, My washer was a Frigidair Gallery front loader,about 10 years old. California Itilian Ciao look inbetween the drum and rubber seal at 10: oclock use a flasflite, I found a thong. ...

...10 years old, that, during the spin dry cycle sounds like the drum is coming loose and about to fly through the top at any time. Matters not if its a smal redistributing the load. no diference tho. ...

...drum bearings. That part used to be covered by a 10 year warranty but not anymore. My machine was less than ten years old and it cost me around 300.00 to fix it. I have paid for my machine 3 times ...

...10 years old I would say but was working fine before this. thanks there are 3 to 4 spring assays that holds the drum from inside that need to be replaced every 2 to 3 years of using. ask the dealer ...

drum on washer wont spin washer does not agiatate or spin . motor spins but does not causing belt to burn.could it be drive gear locked up? It's not worth fixing if it's 10 years old or more, better ...

...drum. Is there an updated part? 2005 why would you do that,you could have bought a new washer with newer technology and for the money and time that went into that,a normal washer lasts from 10 to 13 ...

...10 years asking too much? I beleive the main reason our washer wore out so soon was the fact that the previous home owners built a wooden 2" x 2" or 2" x 4" frame with 1/2" plywould over the basement ...

...10-15 years old. any ideas? Thanks, Miriam Check the fit of the agitator to the bottom of the drum. After this many years, it may have warped up to make a gap. Run a rag around the joint to see if it ...