Maytag MFF2557HES Stainless Steel French Door Refrigerator "bad overload protector" Questions

...it from compressor and if its faulty it shake and sound busted. might be bad compreesot that coaused that (which should be covered under 5 yr manu. warr) adnthat comes with new overload ...

...protector rattles when i shake it just stopped working. freezer defrosted and compressor wont stay on. i took of the overload protector and tested it. I got 0.0 caused by voltage flutuation

overload protector is not open and there is still no 120VAC at the compressor with the thermostat turned all the way up then the answer is a bad thermostat. If there is 120VAC at the compressor and it

...bad. or 2 the overload protector is open If you are able, unplug the freezer, disconnect the two wires the attach to the cold control, jumper these wires, plug in the freezer and if the freezer then ...

...bad? If so I'll junk the freezer given what I paid for it. I'd have to pay someone to repair it. Should I try replacing the overload protector again? Any other ideas? It is still being made. Have you ...

...my response. Thanks. If you live in the Denver area, I can help you. the ptc overload relay on the compressor is bad,soon the refrige wont be cold either,its on the compressor in the rear of the ...

...is a bad relay I can replace to get the refridge working again? It may be the thermal overload protector clicking due to a locked rotor in the compressor. A bad start capacitor can cause this

...OVERLOAD AND WHERE L1 WIRE COMES IN FROM THE HARNESS. IF ALL THAT CHECKS OUT THE COMPRESSOR MIGHT BE BAD OR DRAWING TOO MUCH CURRNET FOR THE FACTORY START DEVICE. YOU DIDN'T NOTE A SERIAL #, SOME OF ...

...the fridge ,pullout the cover and you'll see the relay and the overload replaced them (no more than $30).If this doesn't solve the problem you have a bad compresor, wich is a much more expensive

overload protector clicking. If your compressor is good then the start device is probably bad. these are usually easy to replace. Remove the start device and shake it. If it rattlles it is most likely