Maytag MDE2706 Electric Dryer "spins heat turns 3" Questions

...heat In order of the likely causes are: 1) The heating element has failed and must be replaced. 2) One of the few (or many) "overheat thermostats" has failed, and needs replacement. 3) A wire inside ...

...heat turns on but the drum doesn't spin and I can't hear a motor. No air is blowing besides what the heat is moving. I open the door and the heat stays on until I set the cycle timer to off. Can ...

...SPINS AND BLOWS, BUT NO HEAT. wHAT MAY CAUSE THIS? Sounds like your heating element is burned out (acually burned threw) when you moved it if the element was weak it may have broke in two along the ...

dryer is spinning but not drying The dryer appears to be working but is not heating or drying clothes. Also the 3 hr delay button comes on every time I turn it on element or thermostat or both........

heat but it doesn't spin. I hear no sounds other than the normal sound of the timer turning. When I push the power button I get nothing. 1. the dryer hums but dosent turn 2. the dryer starts and stops

...hooked new plug up to dryer turns on and spins but no heat wiring problem? Hi, Here is a tip that will help you with changing your dryer plug. Dryer Cord and Wiring Dryer 3 Wire or 4 Wire ...

heat if a fuse or a circuit breaker is not working. 2. Check for the amp reading at 240 V, it should have reading of 24, 21 and 3 amp (approx.) for 2 lines and neutral respectively. 3. Heating element

...spins for 2secs. exactly and cuts out spinning before it can gain any speed. no speed If the oven doesn't heat evenly or doesn't heat at all, the oven thermostat may be malfunctioning. First, ...

...3 cycle dose not turn on but it gets heat the belt is fine, it was working fine then one day out of the blue i turned it on and it was not starting noticed it was still heating up makes no noise not ...

3 minutes with settings on heat , then open the door and peer thru to the back while the tumbler is spinning. if you don't see part or full radiat heat. the heating coils will have to be replaced. you