Hunter Ceiling Fan Light Switch Control "need wire 3 speed" Questions

...to operate a 3 speed fan, you will need to have 4 wires going to the fan from the switch-----one wire is the common Neutral, the other three are : a single wire for each speed. Good luck, ...

...wire from the new switch. Getting no power on the first two speeds and only a humming sound on the third speed. Can you help! Fan is wired wrong, but you need to test using multi-meter.Buy cheap ...

need to replace the switch that has ,hi,low,med off on nit? please Help Lakewood Fan has 3 wires cut from the switch that has off,med,low, hi on it .I want to replace the switch. please tell me how? ...

...need to get a compatible switch. Otherwise eliminate the medium speed (blue) wire and use the switch you have. If the fan has a wire connector system just cut the copper tip even and place a orange ...

...need to match the 2 wire switch... to the 2 wire fan...!! Most notably Casa Blanca has two vintages of switches... each requiring their own interface at the fan ... Hunter also (once upon a time) had ...

3 speed switch. I replaced the switch which was slightly different than the original. Now the fan has only two speeds, low and high. Two positions of the switch set the low speed, one position sets it

...3 speed pull chain switch? Need to know where wires go (L-1-2-3). Is Kenroy its own brand or does some other company make them Try ...

...need 2 extra pieces of wire. Stick one wire in 2 and the second wire in 3. Now, get your capacitor and hook one side of it to the red wire and position 2, then hook the other side to the wire you put ...

...need wiring diagram please I ran into this when replacing the 3 spd switch. The replacement switch has a pair of connections at each position; you would assume the two connections are electrically ...

need to put different color electrical tape as a marker, on each wire. or ,to be cheap, you can use white paper,scissors to cut paper,and pencil and write 1,2,3,4 on the paper and tape to the 4 switch