Question about Fisher and Paykel Washing Machines
...1 minute. See if that works. there really is no 100% way to diagnose. sounds like the ctrol board in the top back needs to be replaced. if you are mech. inclined you can follow this procedure. 2. ...
...1 minute to when you next use it what is possibly wrong if it comes back isa bad wiring connection between the 2 controls or the main control is defective I hope this helps Gene Circuit Board Medics ...
...power cord if there is any fluctuation in power, so it makes since that this part fails more than the mcu. There is no Master reset. The only thing you can do is unplug for 1 minute then plug back
...1 minute after load cycle starts, changed board, same code, help. priced new lg washer front loader at $400, board cost me 200. Fotunately vendor gave full credit. thinking of just buying new unit. ...
Kenmore HE2 won't finish spin cycle My Kenmore HE2 washing machine stops about 3 minutes before the spin cycle ends leaving my clothes clean but very wet. There are no codes. It just goes through the ...
...then flashes "dl" ?F21? (AKA SD) is a Long (SLOW) Drain error (LD). If the drain time exceeds 8 minutes this error code will be displayed. In addition, a ?SUDS? error may also be displayed. This ...
...minute. Plug in the washer or reconnect the power. Re-select the cycle and press Start. NOTE: If the error remains on the display, and all of the other conditions above have been checked, call for ...
Question about Fisher and Paykel Washing Machines
...than F and will not let me cancel or get the door open untill I will unplug the washer for a few minutes . 1. Unplug washer. 2. Remove the outer portion of the door bellow. This is the gray rubber ...
Question about Fisher and Paykel Washing Machines
...there is an error signal of an "F" and then what appears to be "dL." I unplugged it and waited 30 minutes - same results. Any thoughts? Thanks, Tom Field 1. Unplug washer. 2. Remove the outer ...
Question about Fisher and Paykel Washing Machines
...minute, unplug the appliance. Wait 15 minutes then plug it back in again. Try the machine again. If it's still faulty, you can try changing the Hall Sensor in the motor, this can sometimes cure the ...
558 questions posted
Usually answered in minutes!
1,514 Questions
200 Questions
88 Questions
87 Questions
45 Questions