Hoover U8171-900 / U8172-900 / U8173-900 / U8174-900 Savvy Bagless Upright Vacuum "replace roller brush strips" Questions

...brush roller dod you examine the end of the actual roller that is opposite from the removal opening. There is a gear that the roller fits over that may have gotten stripped when it became tangled. ...

...brush roller itself may be warped, or the bearings may be starting to wear out. Replacing the brush roller may solve the entire problem. Good luck. Mark I imagine the roller is wooden and bent , ...

replace Riccar Roller Brush Bristles. I can not even figure out how to remove the old bristles. On the belt end, there is a clip #59 to remove then you can take the brush roll apart, replace the brush

and clean or replace the roller and bushings. It's possible that the problem is actually in the blower, but most of the time a roller bushing or a foreign object caught under the roller is the culprit

...of the vac powers the brush roller, additionally the carbon brushes may need replacement..far cheeper than a motor.or your belt may be stripped or streched due to string or hair binding the ...

...brush roller would fix the problem by replacing the 'worn" brush (same height so bristles must therefor soften and flex with use?) This must only mean that the vac head rides on the spinning brush as ...

...replace the brush block. Here is what that brush block should look like. http://www.vacuummedic.com/product.php?id=206 Good Luck!  Hello, this is Ava with Think Crucial. There are ...

...wrapped around the end of the brush and pulled it out. Help? If this model has a cogged belt, it may need to replaced. When you cath stuff in the roller some times cogs get stripped off of the

...replace the roller brush wth bearings. i just recently had to replace my wifes on her electrolux. i was able to order the parts online at sears parts direct, but there are many places to get them ...

...replace the brush roll strips on a Riccar/Simplicity metal brush roll? I have removed the clutch assembly and the shaft from the metal roller. There's a metal cap remaining on one end - on the other ...