Self-Propelled models have two belts, a flat belt and the V-Belt. This V-Belt is the one that drives the Brush Roller. After about three months, most belts stretch out causing them to slip. This means
Question about Hoover Vacuums
...DRIVE BELT ON A HOOVER WIND TUNNEL SELF PROPELLED ROLLER BELT BROKE,SELF PROPELLED BELT CASME OFF PULLEY HOW DO I GET IT BACK ON? Take the brush belt and slip it over the pull into the groove. Then ...
.... If it isn't broke, the part that the cable hooks to (actuator)may be broke. Could be the flat belt, they stretch after awhile and will just slip and drive the transmission or brush roll under
...drive belt has a lot of slack in it. Its not worn, I've only used the vac 4 times.I suspect the idler pully some how slipped off.Can you tell me how does it go back on? The idler pulley is ...
...belt i can supply these for all vacuum cleaners at my website. 2. The drive shaft has actually moved slightly - this can happen when 1 or more of the mounting points for the motor cracks or breaks ...
...drive belt comes off the stainless steel end only on my self-propelled Hoover Windtunnel vac. I have installed a new belt - and it is the correct one - but it still pops off periodically. There is no ...
...drive belt (#38528035). Replacing this belt a million times, as many others have recommended at this site ad naseum, would have never solved this problem in a million years! I used my trusty Phillips ...
...drive belt to get it to rotate I had the exact same problem with my Hoover U6485-900 Anniversary upright, self propelled, vacuum. It would move backwards and forwards, had good vacuum, but wouldn't ...
why did self propel stop working? Rubber drive belt broke or slipping.
64 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions