...subs to 2 ohms How do i wire two fifteen inch 2 ohm (4 ohms total) subwoofers to a monoblock amplifier at 2 ohms? Hello familia_gome, If you have 2 subs that are 2 ohms, the final impedance will be ...
...2 ohm subs you only have 3 options of which only 2 will be a usable solution: 1. 3- 2ohm dvc series at sub parralel at amp = about 1.33 ohms at the amplifier this is the best option to get the most ...
a 2 or 8 ohm load. Usually no difference in Theile Small Parameters.... Only wiring configuration - to get the most power out of your amplifier. Thanks for using FixYa - a FixYa rating is appreciated!
a 6 ohm load, but the amp won't put as many watts into a 6 ohm load. Most are optimized for 4 ohms or 2 ohms. And it's not good to run subs in series anyway. Here's the wiring diagram. Hope this helps
Question about MA Audio Car Audio & Video
and nets a 4 ohm load for your amplifier. There is no other configuration for wiring one Dual 2 ohm sub. Thanks for using FixYa - a Very Helpful Rating is appreciated for answering your FREE question
Question about Alpine Car Audio & Video
...2 ohm 2 12ich alpine type r's to box terminals? I have a mrp 1000 alpine amp, how do i wire these to get 2 ohm to the sub box. What size of speaker wire do i use. Dual 4 ohm subwoofers can only be ...
subs dual 2 ohms or dual 4 ohms. 1042s are dual 4 ohm subs so if you wire them both in paralel it will drop both subs into a 2 ohm load for each sub that is pos of one coil to pos of sec coil then pos
Question about Alphasonik Car Audio & Video
wiring-your-subs-dual-voice-coils/ 2 things you MUST know before wiring. The impedance of each coil. The lowest stable impedance of the amplifier. DO NOT WIRE YOUR SUBS LOWER THAN THE STABLE IMPEDANCE
...subs can you show me how to wire the amp as well it says on the amp its 2ohm stable A normal wiring setup to produce a 4-ohm load is what you usually see - each speaker is wired to one channel of the ...
...both subs in parallel, you get a 4 ohm load. The other outlandish option is to get 2 more dual 4 ohm subs. Then you can get to a 2 ohm load. Sorry, I'm sure that's not what you wanted to
7 questions posted
Usually answered in minutes!
31 Questions
19 Questions
11 Questions
12 Questions
9 Questions