Question about Altec Lansing Audio Players & Recorders
4 ohms.the average is 4 ohms because the impedance goes up and down depending on frequency. So if you say 4 ohms is the max. you don't want the 4 ohm speaker going lower and stressing/damaging the amp
...4 ohm load is much higher than with 8 ohms. You also take the risk of cooking your output transistors.It is up to you to decide if the risk, the neccessary self imposed volume limiting and the added ...
Question about Audio Players & Recorders
...4 ohms @50 watts each, in place of my 2- 4 ohm computer speakers with built in amp by sony, the little towers with volume knob. Do you think it will work ok? Do you think that the amp in the sonys ...
...4 ohms or 8 ohms. Ohms is written as an omega symbol. You have to match the ohms rated output of the computer to the speakers, or you can either blow the speakers up, or overload your amplifier and ...
...4, 8 or 16 ohms. Contact the manufacturer if its an expensive name brand. Check the manufacturer's literature to determine the Ohms, it will be listed. You have turned up the ...
Question about Altec Lansing Audio Players & Recorders
...on back. Measure resistance across speaker with ohm meter, should be 8 ohms. If not 8 ohms, replace speaker with higher wattage same sized speaker. These speakers are only 4 watts and blow out
Question about Juster Audio Players & Recorders
What is the voltage polarity ac or dc of the power adapter for SP-613 speakers? this is actually the product description for your speaker Product Description Front Speaker Unit: 1inch +6.5inch ...
No left channel output from Labtec cs-900 computer speaker. Absolute silence. I had been using these speakers with this PC for more than 4 years without problem. Normal output from right speaker. Get
...4.5inch across. I could replace the whole woofer or just the cap.If possible, I'm looking to buy a woofer with rubber suspension, the original one has paper suspension.Logitech is no help in this ...
Question about JBL Audio Players & Recorders
try? Is there something specific I can look for if I open it up? Check the impedance or resistance of the speakers with an OHM meter - should be around 4 to 8 ohms. If you don't get a reading, its bad
74 questions posted
Usually answered in minutes!
143 Questions
114 Questions
88 Questions
77 Questions
70 Questions