Fisher and Paykel 24 in. DD603H W Built-in Dishwasher "dd603 heater plate" Questions

dd603, the heater plate in the bottom of the drawer acts as a dropping resistor in the power supply circuit. The main computer is often replaced incorrectly when the the machine is "dead". The correct

...DD603 series. The top drawer stopped working and you could smell electrical burning. I had a repair man diagnose this as a heater plate. Is this something i can replace myself? Thanks Al Arnold ...

DD603 gives me an F3 and stops before wash ends, then beeps. Hi- The F3 fault is related to the water temperature. Probable cause is the controller not sensing the correct water temp. It is also ...

...DD603 follows the same principle. http://www.scribd.com/doc/6462163/DD601V2-Manual Mat Please rate me Hi- sounds like the controller is not sensing the right temp or possibly the heater plate is bad. ...

...DD603 model has lid actuator motors, not the inflatable style seal. It sounds like the lid motors are in the DOWN position. Since the machine is "dead" what may have happened is the heater plate ...

dd603 has F3 and spanner on display and it beeps F3 Water temperature sensed at greater than 85°C ( 185°F) 1 Is the incoming water temperature greater than 85°C (185°F) Y: Adjust ...

DD603 model & top drawer totally dead, no lights but bottom drawer 100% Your thoughts plse. Believe it finished normally but dead when going to wash new load. It's like it is switched off ...

heater plate at the bottom of the drawer. To confirm if the controller is operational or not, press Keylock and Start/ Pause button together for 5 sec (press Keylock first) and see if the Lights light

...DD603 dishwwasher indicates that the "temperature sensor is faulty. Question: where is it located on the machine and how do I replace it? The temperature sensor is located on the heater ...