Question about GE Dishwashers
...between the interlock switch and the other switch (?) flew out. The peg slides in-between two white plastic "legs" that seemed bent. Tried to straighten them, re-inserted the peg and spring. Removed ...
...plastic). You will see a circuit board, that board has a screw in the middle/left. That screw, and a 'vertical' piece on the left of the circuit board measure water on the floor of the washer (by ...
Question about Fisher and Paykel Dishwashers
board. The plastic cap is held down with small tabs, depress the tabs and slide the cover off. The power cord is screwed down to the mains filter. Fisher Paykel Dishwasher Repair Video Unplug and turn
...plastic cover over the flood sensor can be gently removed by pressing down and sliding it to the right. Once the cover is off you can again mop up the excess water before using a hairdryer to fully ...
...plastic cover over the flood sensor can be gently removed by pressing down and sliding it to the right. Once the cover is off you can again mop up the excess water before using a hairdryer to fully ...
...board and connectors for signs of over-heating or plastic melting. If so, you found the cause - a loose connection. Chances are it melted the solder connection on the other side of the board. If it's ...
Question about Dishwashers
...plastic moulding. If you remove the two cable plugs and remove the two screws holding the moulding in you can then take it out. Carefully open it by pulling back the clips, and inside is a small ...
plastic float gets caught or trapped in the raised position, the water can't enter the dishwasher. If the float switch is defective, you need to replace it. Some of the switches that control water are
...board and a plastic piece of a bird feeder. Shocks me that this little stuff made sucha hugh sound. Be sure you get it back in the same orientation. The bottom plastic must align to the drain in th ...
...board. take the cover off and carefully disconnect the wires. the wire ribbon that connects the control panel is a little tricky. You have to seperate the plastic connector block and the ribbon will ...
86 questions posted
Usually answered in minutes!
809 Questions
201 Questions
174 Questions
104 Questions
87 Questions