Question about Rockford Fosgate Car Audio & Video
How to bridge a 1 channel 1000 punch 55amp You can not bridge a 1 channel amp. Bridging is when you combine the output of a bridgeable two channel amp into one channel, typically to power a sub woofer
...bridge 2 channels of a 4 channel amp (or get a 2 ch amp and bridge it) and connect the sub. Bridging = connect + of sub to + of one channel, and connect - of sub to - of *other* channel. Check amp ...
how do i bridge this amp That looks like a single channel amp, therefore there is nothing to bridge. You need at least two channels to bridge them together combining there power output to one channel.
...amp for each speaker at 8 or 2 ohms? what is best? Your amplifier is 4 channel... and only 2 ohm stereo capable. You will get the most power putting 1 subwoofer wired in parallel on each BRIDGED ...
channel. That amp wont run bridged at 2ohm rite. You are correct, the amp will not support 2 ohms bridged. your best bet would probably be to have one voice coil on each channel. You could run them in
bridge the speaker outputs; positive from channel two(2) , and negative from channel one (1) : Positive from channel four (4) and negative from channel three (3). I believe this will provide 140 watts
Question about Performance Teknique Car Audio & Video
...bridge mode on amp Bridging an amp is as simple as using both channels for one hookup. By this i mean use the negative slot from one channel and the positive from the other. Not all amps are ...
...Bridge channels 1/2 to one of the subs and channels 3/4 to the other one. But the amp is only rated for 75 watts RMS per channel and Pyle products are sometimes rated higher than their real ...
Question about Rockwood Car Audio & Video
...not brigeable. If bridge able the bridge terminals should be marked (usually the positive of 1 channel and the negative of the other channel). Under no circumstances bridge to less than a 4 ohm
Question about MTX Car Audio & Video
...Bridge MTX Thunder 404 400 watts into one channel The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. ...
16 questions posted
Usually answered in minutes!
6 Questions
20 Questions
19 Questions
11 Questions
16 Questions