Question about Hotpoint Washing Machines
...machine before.hope you can help because the mould has started to come off on to the washing many thanks hi, has the seal been replaced?if not use an old tooth brush and clean it with tooth paste it ...
...rim of the opening (DO NOT grab the wash tub). Tilt and slide cabinet forward to remove. There should be a counterbalance spring in the bottom rear of the machine. Sometimes the mounting hole in the ...
rim as it spins and cause a leak on the floor. This kind of leak will cause water to appear as if it is leaking between the top and the cabinet. Word of caution- the water pump is electric, and if you
...rim. Do I need to tilt the washing machine on its side. The model is a SERVIS M9813S. Thanks Hi, I'm not familiar with your particular model, but there is most likely a very similar type of clamp ...
My Whirlpool 6100 is bouncing around. I have changed the shocks and no change. I have checked the concrete weights and they are sound. up to 400 revs it is stable This could be due to the basket being
Question about Fisher and Paykel Washing Machines
My fisher and paykel smart drive starts & fills but as soon as it trys to wash, the tub slightly goes round then it starts error beeping. I tried to spin it, it will rinse but not spin does the ...
...rim edge just behind the door seal) (and not too much force)if there is any play movement or it rattles then yes its confirmed, if the back of the machine is removed you may also notice brown rust ...
Rust inside my washer I have a top load washer. I have a problem with rust around the inside rim of the washer. It's the area under where the bleach cup is located and surrounding area. I've sanded ...
...rusting out for about 5 years and that is the area where you put the bleach. The second area is under the top rim that sits over the drum. I recently noticed pieces falling out form under this area. ...
rust from under their top rim Like cancer, only real cure for rust is removing and replacing the panel with another one. As a stop gap measure you can remove the panel and grind down to bare metal all
1,828 questions posted
Usually answered in minutes!
200 Questions
88 Questions
87 Questions
45 Questions
22 Questions