Hoover HTC243 Top Load Washer "timer switch" Questions

...timer switch stops with load of wash and water inside during the first cycle; circular timer dial also stops moving clockwise. My guess is a defective motor/timer - are they all one unit? If you are ...

...timer switch is usually the largest dial on the main control panel. It can be either a mechanical device much like a simple clock, or completely electronic with just a digital readout. The timer runs ...

...timer switch is defective.....or the clock that spins the timer switch is defective or wiring to specific areas to the timer switch is defective...in any case....check for this problem at the timer ...

switch and the timer may be faulty. Test both components and replace them as necessary Servicing the Temperature Selector Switch This control panel switch regulates the temperature of the water in the

...timer is shot. In some models , lid switch controls everything which may be your problem .Try manually operating lid switch or jumping it with jumper wire.Or just replacing. Its' the easiest to ...

timer switch?? Also, direct drive assembly sounds "labored" since this timer problem showed up. I'm hearing a "worn out" kind of sound during spin cycle when it will run??? Any feedback is appreciated

...timer is a multiple switch, turn it through its cycle and test each pair of terminals in turn. The meter should read zero at all of these points. If one or more readings are above zero, the timer is ...

...switch and timer working because when lid closed, timer keeps counting down but washer doesnt run. when lid opened again, timer pauses. already reset breaker and added more coins, no change. reset ...

...timer switch checked for bad or burnt contacts...you might have to replace the timer...in some cases, the timer switch can actually be opened and cleaned but that's assuming that the contacts haven't ...

...timer switch, you will need to set your multimeter to read ohms. Set the timer on the biginning of a cycle and pull the knob to turn the switch to the on position. Open the controls panel, take a ...