...pressure is fine. Its really odd. If anyone can help it would be muchly appreciated. Hi All The solution is a faulty solenoid valve, either the hot or cold valve depending what temperature you are ...
Question about Hoover Washing Machines
...solenoid diaphragm all the way (minimum pressure should be between 10-25 psi). 2. The filter screen on the hot water side needs to be cleaned thoroughly. 3. Valve is defective. If you have tried ...
...pressure before, the problem could be the valve going bad. Assuming this is a TOP LOADING Kenmore, the following link explains how to replace an inlet valve: ...
solenoid ~ 60 ohms 4.The thermistor ~ 10K ohms # When this fault exists you can empty the water by removing the tube to the Pressure Xducer and using a tube from your mouth to blow into it HARD!!! The
control panel. The pressure switch turns the water off when the water in the wash tub reaches the appropriate level. If your problems continue, you may have a pressure switch that is beginning to fail
Question about Fisher Washing Machines
solenoid ~ 60 ohms 4.The thermistor ~ 10K ohms # When this fault exists you can empty the water by removing the tube to the Pressure Xducer and using a tube from your mouth to blow into it HARD!!! The
pressure before, I would assume the water inlet valve is the problem. You can attempt to remove it and clean it if you like, or....if you're going to go through the steps to remove it, just replace it
Question about Hoover Washing Machines
...replacement warranty on the pump - for (at this time, July 2009) about $124 total. However, before you do anything you can run the washer diagnostics by pressing the following key sequence to put the ...
Pressure Switch, and Central Control Unit (CCU). 3. Check/Clean Drain Pump Filter of foreign objects 4. Check for Drain Pump Failure. 5. Check the Inlet Valve for proper shut off 6. Check the Pressure
152 questions posted
Usually answered in minutes!
99 Questions
66 Questions
56 Questions
46 Questions
40 Questions