Hoover H130E Front Load Washer "stop button flashing washing" Questions

stop button keeps flashing every time i put it on a wash cycle my swan washing machine stop button keeps flashing can u tell me why this is happening please Yes, the machine has found a fault and wont

...button contiues to flash unable to use washer even if power is turned of My washer did the same until i relalised that after the wash when light is flashing, turn control to stop position and wait ...

...the control panel start flashing and as a result I can't run the wash cycle. I've tried holding down the start button but that doesn't stop the buttons flashing. Any ideas? Thanks!! Sarah which

...lights flash and the on/off button won't stop flashing. It seems to take a really long time to wash and doesn't seem to change steps, from wash to spin etc. Refer to manual & clean out your

...button on left hand side and on right hand side which show go and stop is also flashing red on stop. I have even tried to put it on a spin cycle and it just humming away and not doing anything. Many ...

button flashing wont start was working ok up till now i have cleaned filter out i even put on a new door lock thinking that was problem it just stopped after a wash was put on it filled up a small bit

...button flash quite rapidly. the wash will not complete on any of the wash programmes........please help very urgent!!!!!! depends on what lights are flashing this is your fault code I have the same ...

...button is flashing.Half way through the load the on/off button starts to flash along with the wash enhance. The machine then stops working. Have tried with washing in and on an empty cycle. wash ...

...stop. The main light flashing is the lock door button. To resolve this issue, try the following steps: Check if the door is securely closed. Ensure that the machine is level and not tilting. Verify ...

...stop button but it doesn't seem to cancel the setting or stop the light from flashing get it checked by and expert it sounds like the board has gone or the door lock is faulty my Hotpoint WT540 ...