Question about Office Depot Office Equipment & Supplies
...sensor no light no switch There are 2 methods. One is a mechanical arm that is lifted by the paper. More often there is an LED light at one end of the ffeed to the cutters, and a sensor at the other ...
It may be that the sensors are dirty - use a cotton bud dipped in rubbing alcohol to clean the sensor light(s) and heads Give a quick spray to cutters with WD40 Replace - turn on - and run in reverse
Question about Fellowes Office Equipment & Supplies
...sensor light. Held in reverse for 1 min. Nothing when I attempt to shred a sheet of paper. Unplug from mains electricity. use a cotton bud dipped in rubbing alcohol to clean the sensor light(s) and ...
...sensor work and the orange light stays off when the sensors are covered and comes on as light is allowed to fall on them. The 1" cube relay with transparent cover on the circuit board can be seen to ...
Question about Fellowes Office Equipment & Supplies
green and middle red light go on but motor does not. does not shred green light and middle red light go on but wont shred and no motor sound Check the sensors on top and bottom of cutters. Clean with ...
light to go out? The door sensor could be bent or broken. There is also a thin piece on the door that pushes the sensor switch. Check to see if it is broken. Try pushing a thin object into the sensor
I have a hsm 225.2 shredder that will go in reverse, but won't come on on the automatic cycle. The light for the door being open will not come on and neither will the power light. One of our office ...
Question about Office Equipment & Supplies
...it If the sensor beam is blocked, the motor thinks there is paper in the shredder. The sensor light maybe dirty - use a cotton bud dipped in rubbing alcohol to clean the sensor light(s) and ...
Question about Office Equipment & Supplies
...light beam is re-established it turns off. Paper dust and oil may cover the LEDs making the machine think there is paper present. Using a Q-tip soaked with isopropyl alcohol, clean the LEDS. May need ...
Question about Fellowes Manufacturing Office Equipment & Supplies
...sensor light lights up. Power is good, since the sensor light turns on when you touch the entry point. However the motor wont turn the blades or even seemingly power them up. plastic gears for ...
15 questions posted
Usually answered in minutes!
69 Questions
20 Questions