...thermal overload, which is covered in the manual. But I would guess that you have let it sit for 30 minutes to cool down and tried again and the vacuum still didn't work. I would think you may have ...
Question about Dyson Vacuums
...and causing an internal overload to trip and then it resets when it cools. When a motor is jammed, it draws a lot of current, which causes heat and open thermal overloads (to protect the
it quit and it won't come back on what do we do? Wait 30 minutes and try again. There is a thermal overload on the motor that you can't reset. Take out all 3 filters and clean or replace them. Gary
Question about Vacuums
...manual switch reset located for the thermal overload . the motor has no external buttons do I need to take the plastic cover off a picture would be great . It depends on what brand and model you ...
Question about Vacuums
...were vacuuming high carpet on the low carpet setting, you may have overheated the motor and tripped the thermal overload... try it again in a few hours and it may have cooled down enough to
thermal overload. Some one will have to remove the cover of the compressor terminals measure input power, inspect the PTC relay, thermal overload, wiring, terminals on the compressor, then measure the
loaded with dust/dirt in the bagless cup. Is their a re-set proceedure? There is a thermal overload switch in the motor. It should reset itself. Let it cool down for a while. And it should start again
Question about Eureka Vacuums
thermal cut off resistor) is located in the housing above the motor. It is a $1 part, if you are handy. Just search for the item under Eureka parts. Bad thing is, shipping is $9 bucks and change. Good
Question about Electrolux Vacuums
...thermal overload, is the bag being full or the bag not being present. Either of these faults would need to be corrected and then the machine switched off and back on to clear them. I hope this helps. ...
Question about Bissell Vacuums
...thermal overload to click off will only restart once cool enough suggest the cause is motor could be full of dust clogged filters that allow motor to breath motor bearings /bushes worn motor past use ...
243 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
146 Questions