...put belt on a Eureka "Boss." Much like a toilet paper dispenser, the motor shaft pully sits in a plastic channel, turning in place on two pegs. I can't squeeze the belt past these pegs. Any ...
...put on the belt on the brushroll, put the brushroll into the housing making sure the marks on the end of the brushroll are the same. Take the spin dial in the front and "hook" the belt till the dial ...
...put a new belt on my vacuum? Take off the bottom plate, there are 2 belts, the V belt (38528034)goes on first, it goes around the pulley then around the brush roll. The Flat belt(38528035), put it ...
...put belt over brush roller just can not find clearance to put belt over motor shaft??? make sure the vacuum is in the upright (locked position) - when you lower the handle, this puts tention on the ...
...to know how to put on the vacuum cleaner belt ub-11 Remove the brush bar. Then link the belt onto the motor spindle. Then insert the brush bar into the belt and snap it back into the vacuum
...loose. When putting the new belt, you need to insert the belt into the pin first and then put the other end of the belt onto the roller. Then pull the roller and put it back into its groove.
...put the new belt on, it immediately burned in half. After that i put the old belt back on since it looked ok still, now its way harder to push across the carpet. I never had that problem before, i ...
...of the brush that the belt connects to.. Put new belt on.. Put the brush back in place.. It might be a bit tough because the new belt will have a bit of tention.. Put plate cover back on and
...put a new belt on, the belt rubs the side of the wall of the vacuum gets real hot and busts. is there any type of washer fitting that goes on the vacuum to hold the belt in place? i dont know i need ...
243 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
146 Questions