Hoover U6437-900 / U6439-900 Windtunnel Bagged Upright Vacuum "belt tensioner upright vac" Questions

...belt or is there something that could be missing to put tension on it ?? Thank You [email protected] Jim, To put tension on the brush, tilt machine forward when upright, move carpet selector ...

...belt incorrectly. When you open the cover on the bottom of your vac, you will see the pulley that moves as you flip the switch from floors to carpet. The belt does not go around this pulley. When ...

...right place then you can spin it by hand (power cord unplugged of course) and make sure it is clearing everything. BTW, the belt has to be stretched to get the beater bar in place like on most ...

...vac, Model U6432-900, and the brush roll will not turn. The v-belt seems too loose to turn the brushroll. The flat belt seems to be tight and working properly. I replaced the v-belt and the brushroll ...

...belt Turn the vac over so the brush is facing up.. There is a cover plate that surrounds the brush.. Take the screws out and remove the cover plate.. Pull up on the side of the brush that the belt is ...

...thumb dial to lock into place and rotate the square handle again . This will release the belt tension onto the motor shaft. Raise the vac up two knotches with the pedal before lower onto the

...Most times when the rollers go bad they break the belt. Replace the roller if necessary Make sure the roller is in correctly and flush and that the bottom plate goes on easily. Good Luck The Vac

...upright vacuum. The belt tensioner will tighten up the belt and make the brushroll spin when you recline the handle into the vacuuming position if the hard/carpet lever is in the proper

upright vacuum. When the belt broke I took it into the shop (because when i tried to replace the belt, the tension was so tight I couldn't get it back together!!). When I got it home I DISCOVERED THAT

...BELT ON MY ULTIMATE UPRIGHT G BAG VACUUM CLEANER. You need to disengage the carpet head from the vac itself. Do this by lifting the headlight and rotating the thumb lock underneath. Then release the ...