...belt is loose- roller brush doesnt turn. Its brand new belt is slipping. we bough new belts and putthem on same problem. Can not find solutio in manual. Is the belt supposed to go around the ...
...belt will come loose. When putting the new belt, you need to insert the belt into the pin first and then put the other end of the belt onto the roller. Then pull the roller and put it back into its ...
Question about Hoover Vacuums
...belt that is loose and slips on the agiator so it will not turn under a load. I replaced the beld, 385280-34, but its the same problem, too loose. Is there a tension adjustment on the tension roller? ...
...belt on my boss 4800 and it is to loose? Does the beater bar needed to be replaced? There is no traction to turn the belt, it spins sounds like the belt is to big you didnt replace with the correct ...
...like the belt is too worn and loose to stay on. Buy a new belt specified for that model of vacuum and install. Ensure that there is only a slight amount of give in the belt when you press the
Question about Vacuums
...belt was likely loose enough it did not have enough friction to burn the belt. Many people assume they got a faulty belt when this happens but it's usually a problem with the brushroll. The brushroll ...
belt is very loose when installed this way, it means you might have to twist it half a turn for it to be on right, you will be able to tell though. because if its loose it wont turn the brush. i think
Question about Hoover Vacuums
...loose paint is stuck in the vacuum. I cleaned out the filters, but I think the problem is somewhere else. I need help Take the bottom plate off where you would install a new belt. the impeller is ...
...belt on the driver seems loose. Is that normal? Call the Bissell Consumer Care at 1-800-237-7691 something doesn't sound right. Are you sure you followed the detailed install instructions that should ...
...Belt Make sure the canister is all the way in and latched (yes this has bit me in the rear a few times). If you grab the handle to the canister (w/o bushing the button) and give it a slight pull and ...
577 questions posted
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions
146 Questions