Hoover U5753-900 WindTunnel Bagless Upright Vacuum "spin brush quits working" Questions

...brush will not spin. Sometimes, if it try to turn the brush by hand (this is tricky to do) it will spin for a second or so but won't continue. It has been been well cleaned. The brush will turn free ...

...taking the brush out and hold it by the ends and try to turn it. It should turn quite easily if it is working good. If not try taking the ends off and clean them out. Also, make sure the belt is

Hi My brushes wont spin on my Bissell Proheat 2X Revolution. I have replaced the large belt and also the small belt. The Machine has worked well and recently the brushes quit spinning Dismantle the ...

spin at all, your turbine is bad and will need to be replaced. Hoover part number for brush assembly:48437022 Hoover part number for turbine: 43191008 My turbine has not failed! The turbine on my unit

brush stops working, then there is probably a problem with the belt. The device is likely set to stop the brush from spinning if the belt tension is not correct. My guess is that the belts have become

spin again? (1) Assure the Brush Control on the hood is NOT set to the OFF position. (2) Remove the brush assembly by pulling/unlatching it from base on each side. (3) Does one of the brushes have the

...brush and a small cog wheel. On the left side, a larger belt goes around both brushes. If either belt is broken, the brushes will not spin. This can happen if you let gunk build up inside the clear ...

miele seb 213 quit spinning on rug My miele seb 213 head quit spinning an squels when vacuuming rugs Hello, this is Ava with Think Crucial. There are a number of reasons why your brush roller has ...

brush-block, which simply releases from the bottom by pushing the retaining tabs free. If you pull this out and attempt to spin the brushes by spinning the green squarish "stick" coming out of the top

...quits after 10 seconds of working. Miele power nozzle quit. I have removed the cover and cut out all hair, strings, etc. The little belt seems okay. When I turn the power nozzle on, it goes for about ...