...pump has failed. What do I do? Hello, what you can check, the float in the tub.their may be something caught under itthe water valve,use a meter set to check ac voltage and check for 120 volts ac at ...
...heat dry cycle. There is about 1 inch of standing water at the bottom of the tub. Pressing Cancel button in the morning gets all the water out of the tub. I've checked the drain pipes, air gap, ...
...pump located near the front, it could be on the left or right side. Also, if your unit has a float switch(flying saucer shaped object near the front of the tub, inside), the seal for the switch might ...
...float switch in base activated. 3flash=heating fault(check element.NTC,control board). 4flash=drain error-blockage in pump or drain system,or faulty water indicator switch. 6flash=water inlet ...
Question about Bosch Dishwashers
...pump works when the red bar is lifted triggering the float micro switch, and water is ejected. I have tried pressing the reset buttons, but to no avail. The most common cause of this is that the ...
Question about Hobart Dishwashers
...Pump starts. Tank heats. Float switch seems good. It is possible that the timer or control board is malfunctioning, causing the machine to rush through the wash cycle. You may want to consider ...
float. Hi, It seems that the flapper breaks off or the spring cannot keep the drain port closed causing the water to drain as it fills,these are the usual defective parts.You might need to disassemble
...float in a toilet tank (if you are familiar with that) you are definitely on the correct path in thinking that the low water issue is your electrical issue. if that heating element isnt submerged in ...
Question about Whirlpool Dishwashers
! Check for a solinoid valve under the machine. This shifts the pump from fill/wash to drain. Sometimes the slug in the coil gets stuck or rusted. Also, a float switch tells the water solinoid to open
...PUMP?. Lack of water to heat. (Unit not filling properly) ? Insufficient water supply pressure ? Fill valve screen blocked or valve not opening fully ? Loose electrical connection on Fill Valve. ? ...
23 questions posted
Usually answered in minutes!
445 Questions
106 Questions
82 Questions
41 Questions
48 Questions