...install the jumper in normal mode? When i switch on my system it automatically opens bios settings and when i exit from it it shows the following message "Power off and reinstall the jumper in the ...
Question about Intel Computers & Internet
...is appearing on your screen then the bios jumper is installed at reset position. so please install this bios jumper of your motherboard and the pin number 1-2 position of bios. it will be ...
Question about Intel Computers & Internet
...the battery and install new battery and also make sure jumper position is proper. Hope this helps. Please rate my response. Thanks. Have a good day. please give it for
Question about Intel Computers & Internet
...mode position You have installed the jumpers in incorrect way,please install with correct way.Keep one piece of jumper in certain chips to set down on mother board. So keep so care with installing
3 sticks then its Blue orange and orange.Also the jumper not be in the clear position. It needs to be in the 2and 3 position.The 1 and 2 position is to clear the c mos.2 and 3 are for normal operation
...provided below; ftp://ftp.aopen.com/pub/manual/mb/mx4ge/mx4ge-ol-e.pdf You'll need Adobe reader installed to view the *.pdf file above. Download Adobe @ http://www.adobe.com/products/reader/ Open ...
...install windows. Unplug the power cord from the power supply. The fastest way to clear the bios password would be to first find the bios/cmos battery on the motherboard. See the picture below. Next ...
Question about EliteGroup Computers & Internet
normal operating position of the jumper is on 1&2. Remove jumper and reinstall to jump position 2&3.Plug the PC back in to the wall socket for approximately 1 minute.The PC will not boot up or
Question about Intel Computers & Internet
...jumper in normal mode position d945gcnl mother board, directly it opens cmos setup page, give save & exit it appers (turn off power and reinstall the jumper in normal mode position) what can be done? ...
...jumper to the correct (normal) cmos setting, ensure that this is done correctly because this could be you problem. if the jumper is in the correct position and all you other hard ware is functioning ...
2 questions posted
Usually answered in minutes!
15 Questions
13 Questions
10 Questions
7 Questions