photo cell is clean.to check it open the side compartment and look for the blue and white wire comming from photo cell,on the reset switch there is a white wire and a blue wire.hook these two wires to
photo cell. press the helpful button and check links below. Kerosene Torpedo Heater Repair Test http://bluegreenworld.blogspot.ca/2013/01/fixing-dynaglo-pro-kerosene-forced-air.html https://www.google
Question about Heating & Cooling
...the place where it ignites Faulty igniter,photo cell and or flame sensor gas valve., see trouble shooting links below. Kerosene Torpedo Heater Repair Test Torpedo Kerosene Heater repair HOW they ...
Question about All-Pro Heating & Cooling
...photo cell.. any help If you can get to the photocell, make sure that it is clean. To test it you need an ohm meter. Hook the meter to it and set the meter to read Kohm.. See what it says, then shine ...
...cell is a photo-electric device that reads the UV rays given off by flame after it has ignited. If it does not 'see' the flame, due to a flame failure OR a cad cell failure, the control circuit is ...
Question about Mr. Heater Heating & Cooling
...photo cell, new K, it has fuel spray,spark but it won't ignite now! .... I removed my motor andhot wired it to an outlet and it worked fine. but when hooked up ....Mr. Heater 36,250 views ... Get ...
photo cell window, a bad ignition module, a mis-aligned photo cell, improper fuel pressure, dirty or clogged air filters, restricted fuel flow, or the fuel cap is not vented. Thanks for choosing FixYa
Question about All-Pro Heating & Cooling
...photo cell, and filters. Im not an expert but I am capable of troubleshooting anything with good info. The electric motor may be rusted tight. Spray it with WD 40 or other penetrating oil to see if ...
Question about Mr. Heater Heating & Cooling
...Cell photo cell. a) Slide Cad Cell out of Cad Cell holder. b) Push the photo cell out of the white rubber Cad Cell housing by pushing on the blue and white wires. c) Clean the photo cell with a soft ...
photo resistive cell failure i bet it didnt really fail it just is coverd up with soot from burning fuel that smoked too much , cell needs to be cleaned , plain ole glass cleaner works well for this ,
98 questions posted
Usually answered in minutes!
354 Questions
282 Questions
85 Questions
62 Questions
44 Questions