Reddy Heater-30-55,000 BTU Variable "adjustment screws" Questions

...loud noise on start up I'm not sure what you mean "adjust resonance screw". I'm going to guess the adjustment screw your talking about is under at screw cover and is the appliance regulator screw.

...The pilot seems to have gotten rather high over the years. In the manual it shows a pilot adjustment area. I looked and found a cap screw. Is this a screw cover or is this the adjustment ...

...tall yellow and will not stay lit? The gas valve should have a setting for pilot pressure; the adjustment screw is probably behind a plug - you'll need a diagram of your exact gas valve (by

my pilot light goes out quite frequently can the flamepilot lightBE adjusted, if so how? Some heater models can be adjusted. If you follow the pilot tubing from the pilot down to the control (gas ...

...and turn on it starts up and then it might run it might not for very long. and what are the two adjustments screw heads on the back of heater . You don't state whether this heater has the old ...

PILOT LIGHT IS TOO HIGH HOW DO YOU ADJUST PILOT LIGHT? on main gas valve there is a port wit a cap on it marked pilot remove cap slowly adjust screw till pipot flame covers proper area of thermocouple

pilot light keeps going out, I think probably a factor of the adjustment screw. Where is it? These are usually in the regulator, there are two regulators on gas heaters one for the main burner and one

air screw setting does anyone know how many turns on the air screw on the reddy heater 55000 this screw is located on the back of the unit next to the air in take filter looks like a jet (no not a ...

Flame keep jumping off pilot and goes out you need to check the pilot adjustment screw to lower the pressure where is pilot adjustment screw? thanks

...adjust with a very small flat blade screw driver...you often need to take the cap off of the pilot adjustment screw on the gas valve and then reach down in there with the small flat blade to turn