Reddy Heater-30,000 BTU Propane Forced-Air Heater "forced air staying" Questions

won't stay lit when i lite my ready heater rep50 c p gas 50,000 btu it will not stay lit. Try www.reddyparts.com for help Propane Forced Air Heaters ReddyHeater 50,000 BTU unable to keep heater lit...

...forced air heater model 30 fsa wont stay lit only stays lit for a few minutes and then wont relite at all if its lit by a pilot your thermocouple is bad the purpose of the thermocouple it to keep the ...

Forced Air Kerosene Space Heater. And finally, you say "propane torpedo lights but doesn't stay lit." Which is it? To really help you, I'll need the correct manufacturer's name & model number. And

...forced air furance will not stay lit. I think it is the thermocouple where do I find the part number it is a model 2634F series 776 furnace. almost all thermocouples are universal just need to know ...

...forced air Model 7970C856 The poilet light stays on but furance burner does not kick on. What could it be? Hello, this could be a problem with the thermocouple or gas valve. Start by replacing the ...

rlp 30 won't stay lit after holding control button 30 seconds rlp 30 will not stay lit after control button is held in 30 seconds. cleared line of air, cleared unit. Chk and make sure the ...

what would cause a unit to not stay ignited? The unit will ignite and fan comes on but the unit will not stay ignited Hi, Here is a tip about troubleshooting Torpedo Heaters Reddy Heater - ...

heater won't stay running how do you adjust the feed in back. had this problem last year,downloaded manual and fixed it but cannot find manual now. Instructions for setting the air pump pressureGood ...

...air? most fan forced wall heaters do not move a lot of air. check the cfm rating on the heater. the fan sucks in air from the bottom and forces it up to the top where the element is. broan and nutone ...

forced air propane heater won't stay lit I get the heater to ignite (Reddy RLP30) but when I release the button after 20 secs it won't stay lit; and I've gone through all of the procedures more than a